|
SHOWER BASES
|
|
Florestone Terrazzo
Model 400 Shower Bases
Architect’s
Specifications
Furnish and install wheelchair accessible Terrazzo Shower
Base Model 400 as manufactured by Florestone. Flanges on
three sides, cast integral, shall be of
galvanized-bonderized steel and shall extend not less than
1" above the shoulders. Shoulders on three sides
shall be not less than 22" inside. Threshold shall be
not more than 2" above Base floor to allow for
barrier free entrance. Drain body shall be brass, cast
integral, and shall provide for a non-caulked connection
not less than one inch deep to a 2" pipe. Removable
type stainless steel strainer plate shall be supplied.
Base shall be manufactured of tan and white marble chips
cast in white Portland cement to produce a compressive
strength of not less than 3,000 PSI, seven days after
casting. Terrazzo surface shall be ground, polished, and
the entire unit sealed to resist stains and moisture.
Bases reinforced with 16-gauge wire.
Options
Offset drain.
Additional flanges. (Drawings required)
|
|
Center drain terrazzo shower base with 1¼"
flange on two sides and double threshold for corner
installation.
|
Some Models Conform to
ADA Requirements*
|
Click for Large View
|
Note: Terrazzo is not designed to be used with anything
that is over 130 degrees Fahrenheit.
|
|
|
|
Dimensions subject to
change without notice
|
Contact Florestone Products to
verify product specifications.
|
|
Standards:
|
|
I.A.P.M.O.
|
International Association of Plumbing and
Mechanical Officials File No. 0687.
|
|
|
|
CAD Drawings are compressed in zip format (.zip)
|
Model PDF