Model 99 Half Round Drop Front
Terrazzo Mop Receptor


Furnish and install half round drop front mop receptor as manufactured by Florestone Products Co. Shoulder shall be not less than 4" high inside and not less than 1¾" wide. Galvanized, bonderized steel flange will extend at least one inch above shoulder on one, two or three sides for installation against stud wall (specify choice). Stainless steel protective cap to be cast integral on drop front. Drain body shall be brass, cast integral and shall provide for a non-caulked connection (lead caulked optional) not less than one inch deep to a two or three inch pipe (specify 2" or 3"). Mop sinks with 3" drains are supplied with a rubber seal for use on ABS, PVC or steel pipe. Receptor shall be manufactured of tan and white marble chips cast in white portland cement to produce a compressive strength of not less than 3000 PSI, seven days after casting. Terrazzo surface shall be ground and polished with all air holes and/or pits to be grouted and excess removed and sealed to resist stains and moisture. Receptor will be reinforced with 16 gauge wire.


Specify 2" or 3" drain size (3" standard).

Dimensions may vary ± ¼ inch. Please check unit before installation.

Note: Terrazzo is not designed to be used with anything
that is over 130 degrees Fahrenheit.

Dimensions subject to
change without notice
Contact Florestone Products to
verify product specifications.


Model PDF
Model CAD

Installation PDF
Pricing PDF
Section PDF
Section CADs

CAD Drawings are compressed in zip format (.zip)

Get Media Viewers
Acrobat Reader
CAD Viewer
IZArc Zip Utility

Contact Us | How to Order | Products

Copyright ©2011 Florestone Inc.